American Bridge Company

Is seeking qualified SBEs

The New Jersey Department of Transportation intends to rehabilitate portions of the Pulaski Skyway in Jersey City, NJ.

The principal items of work consist of:



Roadway Items (mainly in Part 1 of drawings, dwg sheets 1-119 and ADD 2):

Excavation, Regulated Material
Disposal of Regulated Material
Treatment, Operations and Reporting Groundwater Management
Milling, Paving, Striping of Roadway & Bridge Deck
New Intersection Layout, Curbs and Finishing
Roadway Striping
Temporary Access Road Cutting, Fill and Riprap placement
MPT Supply & Placement
Lane Closures
Landscaping
And more…

Bridge Items (mainly in Part 2 thru 4, dwg sheets 120-667):

Broadway Ramp Demolition and Replacement
Static Pile Load Test
Micropiles Supply and Installation (Type A & B)
Structural Steel, (Approx. 1,239,300 lbs)
Rehabilitation Steel Supply
Reinforcement Steel (Stainless Steel & Galvanized)
Elastomeric Bearings
Structural Bearings
High Load Multirotational Bearing Assembly
Strip Seal Expansion Joints
Modular Expansion Joints
Steel Repair, (Various Type / Location)
Structural Steel Repair (Various Locations)
Concrete Pier Column and Cap
Concrete Bridge Deck, HPC
Cast-in-Place Exodermic Bridge Deck System, HPC
Concrete Bridge Deck, HPC, Lightweight Conc.
Fiberglass Pipe (Various Size)
Bridge Downspouts and Drainage Supply/Installation
Pneumatically Applied Mortar
Temporary Shielding Supply, Install and Removal
Erosion Control Measures
Roadway Lighting
ITS Supply and Installation
Temporary Tower Fabrication and Supply
Bridge Painting for Repair Work and New Ramp
Bridge Monitoring Systems
Epoxy Waterproofing
And more…

Plans and specifications on the above referenced project can be obtained by clicking on the orange link at the top of this notice.

There is a 9% SBE goal on this project. American Bridge encourages all SBE firms to quote the scopes of work they are able and certified to perform.



Your quote must conform to all requirements of the bid documents, including but not limited to the plans, general provisions, special provisions, specifications, and contract for construction of the owner/agency (including addenda thereto) and be in compliance with all federal, state, and local laws.

In the event that your firm is awarded the project by American Bridge Company, you will be required to execute our standard subcontract or material supply agreement, which is available for your review upon request. Subcontractors, dependent on scale of scope, may be required to furnish a conforming certificate of insurance along with payment and performance bonds before entering into a subcontract, the cost of which should be included in your quotation. Suppliers, dependent on scale of scope, may be required to furnish a supply bond before entering into an agreement.

Please note that American Bridge is a safety conscious company, and establishment of a safe workplace will receive the utmost attention. All site personnel will be required to adhere to the safety requirements of American Bridge Company and governing agencies.


Should you require assistance, or additional information concerning the above project, please contact Chad Ford (917.559.3235, cford@americanbridge.net).



American Bridge Company is an Equal Opportunity Employer